Pass Christian floor coatings, done in a day
A lot of elevated rebuilds with slab-level garages and storage underneath, which are wetter than an ordinary garage. Residential floors are usually a one day job start to finish.
Harrison County, MS
Floors we coat around Pass Christian
A lot of elevated rebuilds with slab-level garages and storage underneath, which are wetter than an ordinary garage.
Salt is the quiet problem on coast jobs. It comes in on tyres, soaks into unsealed concrete, and sits there pushing back out. Grinding removes the loaded surface layer so the new floor is not fighting it from day one.
What a Pass Christian job usually involves
We get asked about basements less here than on higher ground, but where there is one it is damp by default, and a coating that works in a garage will not necessarily hold down there.
One visit, one day, then 48 hours before the car goes back on.
A lot of the calls we take start with somebody having tried a big-box garage floor kit. Those sit on top of sealed concrete and peel, and the removal is more work than the original job would have been.
Where a property has been rented out the slab has usually had a harder life than the owner realises. We would rather look at it than quote off a description.
The slab decides the spec.
Before we quote anything
Gulf Coast concrete carries moisture. Slabs poured on sand without a vapour barrier wick water up through the mix continuously, and that vapour pressure is what lifts a coating months after it looked perfect. We test for it before quoting, because the honest answer sometimes is a moisture-tolerant system rather than standard epoxy.
Full flake broadcast means chip thrown to refusal, so the floor is a continuous layer of vinyl rather than a base coat with decoration on it. That is what gives the texture its grip and what stops the colour wearing through.
Living with it afterwards
Keep grit off it and a coated floor lasts. Grit under a tyre or a boot is abrasive, and abrasion is the only thing that genuinely wears a good topcoat.
Sunlight through a garage door will fade a cheap floor unevenly along the door line. UV-stable topcoats exist precisely for that.
Most asked for here
Everything else is on the services page.
Commercial work around Pass Christian
Commercial work in a town this size is usually small and specific. One wet room, one kitchen, one shop floor that has to be closed for the shortest possible time. Those jobs get planned around opening hours from the first conversation.
The honest answer for most homes in this area is that it is a one day job on a sound slab, and the only thing that changes that is what we find when we start grinding.
The full roster runs to seventy five different rooms, from garages through to food plants and clean rooms. It is all on the services page.
Why the prep matters more than the colour
New pours need to cure before they are coated, and the wait is longer than most people expect. Coating green concrete traps water under the film. We would rather push the date than come back to a blistered floor.
Older residential slabs in Jones County often have a soft top layer from being finished too wet. It looks solid and crumbles under a grinder. If we find that, the fix is grinding past it to sound concrete rather than coating over a layer that is already failing.
Slip resistance comes from profile, not from an additive stirred in at the end. Where a floor will be wet we build the texture in with graded aggregate and we tell you how it will feel underfoot.
Grinding is most of the job.
Getting to you
We work out of Laurel and cover roughly a hundred miles in every direction. That takes in Jones County, Rankin, Simpson and Lamar to the north and west, the whole Mississippi coast from Bay St. Louis through Biloxi to Pascagoula, across into Baldwin and Mobile County in Alabama, and west to St. Tammany Parish.
Pass Christian sits in Harrison County. See the other towns we cover on the Harrison County page or the full service areas list.
Choosing somebody to do our Floors was a hard decision but I am so happy we picked ICM coating masters. The results are beautiful and The time and effort put into the work was amazing.Verified review
How the day runs
Moisture gets tested before resin gets opened. We arrive with the grinder and the dust extraction, and the first stretch is noise and containment rather than anything that looks like progress. Getting the slab open and clean is what the rest of the day depends on.
Cracks get chased out and filled, high spots come down, and any old coating comes off rather than getting buried. Then the primer goes on and the day becomes a sequence with cure windows in it. A typical garage is a one day install. You are walking on it that evening.
Kevin Garner set this up in 2021 for his family to carry on. Nothing gets lost between the quote and the floor because it is the same people doing both.
Warehouse floors want a scrubber with the right pad, not the most aggressive one available. If you want to see blends first, the chip deck comes to you, and there are finished floors on the gallery page.
Pass Christian questions
Do you cover Pass Christian?
Yes. We are based in Laurel and Pass Christian is inside our normal working radius.
How long does a garage take?
The whole system goes down in one visit on most homes.
What is the slab likely to need?
A lot of elevated rebuilds with slab-level garages and storage underneath, which are wetter than an ordinary garage.
Can you match a colour?
Yes. The chip deck comes to you so you choose against your own light.
Do you do commercial work here?
Yes. Shops, kitchens, clinics and warehouses across Harrison County.
How do I get a quote?
Call 601-319-9619 and describe the room, or send the details and we will come look at the slab.
Get us out to see it. That is the only way to be accurate.
Family run out of Laurel since 2021, Duraflex certified. Covering Laurel and south Mississippi, the Gulf Coast, coastal Alabama and St. Tammany Parish. Send us the details or see finished floors.