Thomasville floor coatings, done in a day
Rural southwest Alabama, residential and light commercial. One visit, one day, then 48 hours before the car goes back on.
Clarke County, AL
Floors we coat around Thomasville
Rural southwest Alabama, residential and light commercial.
Slabs around Laurel and down toward the coast are mostly 1970s to 1990s pours, and they were finished hard. A hard-troweled surface has almost no porosity left, which is why paint peels off it in sheets. Grinding opens that surface back up so resin can key into the concrete instead of sitting on top of it.
What a Thomasville job usually involves
Commercial work in a town this size is usually small and specific. One wet room, one kitchen, one shop floor that has to be closed for the shortest possible time. Those jobs get planned around opening hours from the first conversation.
One day down for most homes. Commercial work is phased to your hours.
Sheds and outbuildings on slab are worth coating if they are being used for anything beyond storage. Unsealed concrete in an outbuilding is the dustiest floor most people own.
Church halls, small offices and community buildings turn up in most towns we work in, and those are almost always scheduled around a calendar rather than around us.
The slab decides the spec.
Before we quote anything
Gulf Coast concrete carries moisture. Slabs poured on sand without a vapour barrier wick water up through the mix continuously, and that vapour pressure is what lifts a coating months after it looked perfect. We test for it before quoting, because the honest answer sometimes is a moisture-tolerant system rather than standard epoxy.
Dark floors show dust and light floors show tyre marks. There is no colour that hides everything, and we would rather say that than sell a finish that disappoints.
Living with it afterwards
Keep grit off it and a coated floor lasts. Grit under a tyre or a boot is abrasive, and abrasion is the only thing that genuinely wears a good topcoat.
Coated floors do not need to be stripped and resealed, which is where the savings against VCT actually come from.
Most asked for here
Everything else is on the services page.
Commercial work around Thomasville
Pool surrounds are seasonal work here. The concrete gets hot underfoot and slick when wet, and a textured coating with a cooler pigment fixes both.
New construction is the opposite problem. The slab is clean but green, and coating concrete before it has cured traps water under the film. We would rather push the date than come back to blisters.
The full roster runs to seventy five different rooms, from garages through to food plants and clean rooms. It is all on the services page.
Why the prep matters more than the colour
New pours need to cure before they are coated, and the wait is longer than most people expect. Coating green concrete traps water under the film. We would rather push the date than come back to a blistered floor.
A slab that has been acid etched instead of ground has an inconsistent profile. Some areas take the coating and some do not, and you cannot tell which until it fails. We grind regardless of what was done before.
Quartz systems are built in layers, broadcast and troweled rather than rolled. It is slower to install and it is the toughest, grippiest thing we lay.
Grinding is most of the job.
Getting to you
Laurel is home, and from here we reach Hattiesburg, Jackson, the Gulf Coast, coastal Alabama and the north shore of Lake Pontchartrain comfortably. Coast jobs and Baldwin County work are a normal week for us.
Thomasville sits in Clarke County. See the other towns we cover on the Clarke County page or the full service areas list.
Choosing somebody to do our Floors was a hard decision but I am so happy we picked ICM coating masters. The results are beautiful and The time and effort put into the work was amazing.Verified review
How the day runs
Moisture gets tested before resin gets opened. We arrive with the grinder and the dust extraction, and the first stretch is noise and containment rather than anything that looks like progress. Getting the slab open and clean is what the rest of the day depends on.
Cracks get chased out and filled, high spots come down, and any old coating comes off rather than getting buried. Then the primer goes on and the day becomes a sequence with cure windows in it. Most houses are done inside a day, then 12 hours to foot traffic.
Kevin founded ICM Coating Masters in 2021 and still runs jobs himself. Nothing gets lost between the quote and the floor because it is the same people doing both.
Maintenance is a dust mop and occasionally a neutral cleaner. No wax, no sealing, no annual reapplication. If someone tells you a coated floor needs yearly maintenance, they are describing their own product failing. If you want to see blends first, the chip deck comes to you, and there are finished floors on the gallery page.
Thomasville questions
Do you cover Thomasville?
Yes. We are based in Laurel and Thomasville is inside our normal working radius.
How long does a garage take?
A day on site is the normal answer for a residential floor.
What is the slab likely to need?
Rural southwest Alabama, residential and light commercial. Some floors do not need coating at all. If the slab is sound and the use is light, polishing or sealing the concrete itself is cheaper and lasts longer. We will say so.
Can you match a colour?
Yes. The chip deck comes to you so you choose against your own light.
Do you do commercial work here?
Yes. Shops, kitchens, clinics and warehouses across Clarke County.
How do I get a quote?
Call 601-319-9619 and describe the room, or send the details and we will come look at the slab.
Call and we will give you the real answer.
Aaron, Kyler and Averie work with Kevin on every install. That is by design. Covering Laurel and south Mississippi, the Gulf Coast, coastal Alabama and St. Tammany Parish. Send us the details or see finished floors.