Biloxi floor coatings, done in a day
Hospitality and commercial work alongside residential. Casino and restaurant kitchens need coving and slip ratings rather than a decorative finish. We grind, coat and topcoat in one visit on most residential jobs.
Harrison County, MS
Floors we coat around Biloxi
Hospitality and commercial work alongside residential. Casino and restaurant kitchens need coving and slip ratings rather than a decorative finish.
Salt is the quiet problem on coast jobs. It comes in on tires, soaks into unsealed concrete, and sits there pushing back out. Grinding removes the loaded surface layer so the new floor is not fighting it from day one.
What a Biloxi job usually involves
We get asked about basements less here than on higher ground, but where there is one it is damp by default, and a coating that works in a garage will not necessarily hold down there.
The whole system goes down in one visit on most homes.
Patios and porches are the other half of the residential work in this area. Exterior concrete goes gray, grows algae in the shade and turns slick when it rains, and a UV-stable textured coating solves all three at once.
Humidity is the constant in this part of the state. It affects cure times, it affects how the resin flows, and in summer it means working earlier in the day rather than pushing through the afternoon.
The slab decides the spec.
Before we quote anything
Control joints and cracks are not the same thing and get treated differently. A control joint is doing a job and needs to stay flexible. A crack is failure and gets chased out, filled with a rigid polyurea and ground flat before anything goes over it.
Thickness is specified from the load, not from a brochure. A residential garage and a forklift aisle both get epoxy, and they are not the same floor.
Living with it afterwards
If something is spilled that should not be there, wipe it rather than leaving it to sit. Coatings are resistant, not immune, and contact time is what decides whether resistance matters.
Keep the drains clear in a wet room. Standing water is not a problem for the coating and is a problem for everything else.
Most asked for here
Everything else is on the services page.
Commercial work around Biloxi
Storage rooms, laundry rooms and utility spaces come up often enough to mention. Small floors, quick installs, and usually the same system as a garage at a smaller scale.
A fair amount of our work around here starts as a phone call about dust. Unsealed concrete sheds fine powder constantly, it gets into everything stored in the garage, and no amount of sweeping fixes it because the floor itself is the source.
The full roster runs to seventy five different rooms, from garages through to food plants and clean rooms. It is all on the services page.
Why the prep matters more than the color
A slab that has been acid etched instead of ground has an inconsistent profile. Some areas take the coating and some do not, and you cannot tell which until it fails. We grind regardless of what was done before.
New pours need to cure before they are coated, and the wait is longer than most people expect. Coating green concrete traps water under the film. We would rather push the date than come back to a blistered floor.
Thickness is specified from the load, not from a brochure. A residential garage and a forklift aisle both get epoxy, and they are not the same floor.
Grinding is most of the job.
Getting to you
The service area runs from Jones County out to the coast and along it. Gulfport, Biloxi, Ocean Springs and Pascagoula in Mississippi, Gulf Shores and Foley in Alabama, Covington and Slidell in Louisiana.
Biloxi sits in Harrison County. See the other towns we cover on the Harrison County page or the full service areas list.
Used a lot of flooring companies over the years on various jobs and lemme tell you you’re in good hands with these guys. From the quote to the finished job they were nothing short of professional.Verified review
How the day runs
We would rather spend the morning grinding than come back in a year. We arrive with the grinder and the dust extraction, and the first stretch is noise and containment rather than anything that looks like progress. Getting the slab open and clean is what the rest of the day depends on.
Cracks get chased out and filled, high spots come down, and any old coating comes off rather than getting buried. Then the primer goes on and the day becomes a sequence with cure windows in it. Most of our residential installs are complete within a single working day.
Started 2021, family owned, and the people on your floor are the people who own it. Nothing gets lost between the quote and the floor because it is the same people doing both.
Do not use degreasers with high pH on a regular basis. They will dull a clear coat over time. Neutral cleaner and water handles almost everything. If you want to see blends first, the chip deck comes to you, and there are finished floors on the gallery page.
Biloxi questions
Do you cover Biloxi?
Yes. We are based in Laurel and Biloxi is inside our normal working radius.
How long does a garage take?
You lose the garage for a day, not a week.
What is the slab likely to need?
Hospitality and commercial work alongside residential. Casino and restaurant kitchens need coving and slip ratings rather than a decorative finish.
Can you match a color?
Yes. The chip deck comes to you so you choose against your own light.
Do you do commercial work here?
Yes. Shops, kitchens, clinics and warehouses across Harrison County.
How do I get a quote?
Call 601-319-9619 and describe the room, or send the details and we will come look at the slab.
Speak to Kevin about what would work here.
The reason quality holds is that the family name is on every job. Covering Laurel and south Mississippi, the Gulf Coast, coastal Alabama and St. Tammany Parish. Send us the details or see finished floors.