Moss Point floor coatings, done in a day
Shipyards, refineries and river towns. There is as much industrial and marine work here as residential. One day on site for most homes. Full cure for vehicles is 48 hours.
Jackson County, MS
Floors we coat around Moss Point
Shipyards, refineries and river towns. There is as much industrial and marine work here as residential.
A slab that has been acid etched instead of ground has an inconsistent profile. Some areas take the coating and some do not, and you cannot tell which until it fails. We grind regardless of what was done before.
What a Moss Point job usually involves
A lot of the calls we take start with somebody having tried a big-box garage floor kit. Those sit on top of sealed concrete and peel, and the removal is more work than the original job would have been.
Single day turnaround on typical residential slabs.
Pool surrounds are seasonal work here. The concrete gets hot underfoot and slick when wet, and a textured coating with a cooler pigment fixes both.
A lot of the calls we take start with somebody having tried a big-box garage floor kit. Those sit on top of sealed concrete and peel, and the removal is more work than the original job would have been.
The slab decides the spec.
Before we quote anything
A lot of the slabs we open up have been sealed at some point with an acrylic nobody remembers. It reads as clean concrete until the diamonds hit it and the surface loads up. That is a full mechanical removal, not a light scuff, and it changes the day.
Cementitious urethane costs more than epoxy and outlives it in any wet or thermally cycled room. In a brewery or a food plant it is not an upgrade, it is the correct product.
Living with it afterwards
Do not use degreasers with high pH on a regular basis. They will dull a clear coat over time. Neutral cleaner and water handles almost everything.
Pressure washing exterior coated concrete is fine at sensible pressure. Holding a turbo nozzle in one place is not.
Most asked for here
Everything else is on the services page.
Commercial work around Moss Point
Where a garage has been used as a workshop there is usually oil worked deep into the pores in one or two spots. Surface cleaning does not reach it. We grind it out and prime over what is left.
Commercial work in a town this size is usually small and specific. One wet room, one kitchen, one shop floor that has to be closed for the shortest possible time. Those jobs get planned around opening hours from the first conversation.
The full roster runs to seventy five different rooms, from garages through to food plants and clean rooms. It is all on the services page.
Why the prep matters more than the colour
A slab poured in sections often has slight height differences at the seams. Those get ground flat rather than coated over, because a coating follows the shape it is laid on.
Basement and below-grade slabs are damp by default. A coating that works in a garage will not necessarily hold down there, so those rooms get a system chosen for moisture rather than for looks.
Polyaspartic topcoats cure faster and hold colour better under UV than standard epoxy clears. They also go down in a wider temperature window, which matters when you are working through a Mississippi summer.
Grinding is most of the job.
Getting to you
We work out of Laurel and cover roughly a hundred miles in every direction. That takes in Jones County, Rankin, Simpson and Lamar to the north and west, the whole Mississippi coast from Bay St. Louis through Biloxi to Pascagoula, across into Baldwin and Mobile County in Alabama, and west to St. Tammany Parish.
Moss Point sits in Jackson County. See the other towns we cover on the Jackson County page or the full service areas list.
Used a lot of flooring companies over the years on various jobs and lemme tell you you’re in good hands with these guys. From the quote to the finished job they were nothing short of professional.Verified review
How the day runs
The honest answer about a floor comes from grinding a patch of it. We arrive with the grinder and the dust extraction, and the first stretch is noise and containment rather than anything that looks like progress. Getting the slab open and clean is what the rest of the day depends on.
Cracks get chased out and filled, high spots come down, and any old coating comes off rather than getting buried. Then the primer goes on and the day becomes a sequence with cure windows in it. You lose the garage for a day, not a week.
We are not a franchise. Kevin, Aaron, Kyler and Averie are the company. Nothing gets lost between the quote and the floor because it is the same people doing both.
Snow and road salt tracked in should be rinsed off rather than left to dry. Salt is more aggressive to the concrete than to the coating. If you want to see blends first, the chip deck comes to you, and there are finished floors on the gallery page.
Moss Point questions
Do you cover Moss Point?
Yes. We are based in Laurel and Moss Point is inside our normal working radius.
How long does a garage take?
The whole system goes down in one visit on most homes.
What is the slab likely to need?
Shipyards, refineries and river towns. There is as much industrial and marine work here as residential. Concrete keeps moving for years after it is poured, and it moves more near the coast where the ground is wet and sandy. That is why we detail edges and joints rather than laying one continuous rigid sheet and hoping.
Can you match a colour?
Yes. The chip deck comes to you so you choose against your own light.
Do you do commercial work here?
Yes. Shops, kitchens, clinics and warehouses across Jackson County.
How do I get a quote?
Call 601-319-9619 and describe the room, or send the details and we will come look at the slab.
Get us out to see it. That is the only way to be accurate.
Family run out of Laurel since 2021, Duraflex certified. Covering Laurel and south Mississippi, the Gulf Coast, coastal Alabama and St. Tammany Parish. Send us the details or see finished floors.