Purvis floor coatings, done in a day
Growth west of Hattiesburg, with Oak Grove adding new construction steadily. You lose the garage for a day, not a week.
Lamar County, MS
Floors we coat around Purvis
Growth west of Hattiesburg, with Oak Grove adding new construction steadily.
Where a floor has been patched repeatedly with different products, each patch behaves differently under a grinder and under resin. Sometimes the right call is removing the patches entirely.
What a Purvis job usually involves
Storage rooms, laundry rooms and utility spaces come up often enough to mention. Small floors, quick installs, and usually the same system as a garage at a smaller scale.
The whole system goes down in one visit on most homes.
Where a garage has been used as a workshop there is usually oil worked deep into the pores in one or two spots. Surface cleaning does not reach it. We grind it out and prime over what is left.
Commercial work in a town this size is usually small and specific. One wet room, one kitchen, one shop floor that has to be closed for the shortest possible time. Those jobs get planned around opening hours from the first conversation.
The slab decides the spec.
Before we quote anything
Basement and below-grade slabs are damp by default. A coating that works in a garage will not necessarily hold down there, so those rooms get a system chosen for moisture rather than for looks.
The chip blend changes how a floor hides dirt. Multi-tone blends with some dark in them stay looking clean far longer than a single pale colour.
Living with it afterwards
If something is spilled that should not be there, wipe it rather than leaving it to sit. Coatings are resistant, not immune, and contact time is what decides whether resistance matters.
Coated floors do not need to be stripped and resealed, which is where the savings against VCT actually come from.
Most asked for here
Everything else is on the services page.
Commercial work around Purvis
Pool surrounds are seasonal work here. The concrete gets hot underfoot and slick when wet, and a textured coating with a cooler pigment fixes both.
Patios and porches are the other half of the residential work in this area. Exterior concrete goes grey, grows algae in the shade and turns slick when it rains, and a UV-stable textured coating solves all three at once.
The full roster runs to seventy five different rooms, from garages through to food plants and clean rooms. It is all on the services page.
Why the prep matters more than the colour
A slab that has been acid etched instead of ground has an inconsistent profile. Some areas take the coating and some do not, and you cannot tell which until it fails. We grind regardless of what was done before.
A lot of the slabs we open up have been sealed at some point with an acrylic nobody remembers. It reads as clean concrete until the diamonds hit it and the surface loads up. That is a full mechanical removal, not a light scuff, and it changes the day.
Polished concrete uses a densifier that reacts chemically with the slab, hardening it rather than coating it. There is nothing to peel because there is no film.
Grinding is most of the job.
Getting to you
We work out of Laurel and cover roughly a hundred miles in every direction. That takes in Jones County, Rankin, Simpson and Lamar to the north and west, the whole Mississippi coast from Bay St. Louis through Biloxi to Pascagoula, across into Baldwin and Mobile County in Alabama, and west to St. Tammany Parish.
Purvis sits in Lamar County. See the other towns we cover on the Lamar County page or the full service areas list.
Choosing somebody to do our Floors was a hard decision but I am so happy we picked ICM coating masters. The results are beautiful and The time and effort put into the work was amazing.Verified review
How the day runs
The floor tells us what it needs before we quote anything. We arrive with the grinder and the dust extraction, and the first stretch is noise and containment rather than anything that looks like progress. Getting the slab open and clean is what the rest of the day depends on.
Cracks get chased out and filled, high spots come down, and any old coating comes off rather than getting buried. Then the primer goes on and the day becomes a sequence with cure windows in it. Residential floors are usually a one day job start to finish.
Aaron, Kyler and Averie work with Kevin on every install. That is by design. Nothing gets lost between the quote and the floor because it is the same people doing both.
A dust mop twice a week does more for the look of a floor than any product you can buy. If you want to see blends first, the chip deck comes to you, and there are finished floors on the gallery page.
Purvis questions
Do you cover Purvis?
Yes. We are based in Laurel and Purvis is inside our normal working radius.
How long does a garage take?
Most jobs need one day of our time and none of yours.
What is the slab likely to need?
Growth west of Hattiesburg, with Oak Grove adding new construction steadily. New pours need to cure before they are coated, and the wait is longer than most people expect. Coating green concrete traps water under the film. We would rather push the date than come back to a blistered floor.
Can you match a colour?
Yes. The chip deck comes to you so you choose against your own light.
Do you do commercial work here?
Yes. Shops, kitchens, clinics and warehouses across Lamar County.
How do I get a quote?
Call 601-319-9619 and describe the room, or send the details and we will come look at the slab.
Call and describe the floor. We will know most of it from that.
We are not a franchise. Kevin, Aaron, Kyler and Averie are the company. Covering Laurel and south Mississippi, the Gulf Coast, coastal Alabama and St. Tammany Parish. Send us the details or see finished floors.